SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMREPAIR INSTRUCTIONSREAR FOG LAMP REPLACEMENT (CADILLAC EXPORT)
2011 Cadillac Escalade Base, AWD

Rear Fog Lamp Replacement (Cadillac Export)

2011 Cadillac Escalade Base, AWDSECTION Rear Fog Lamp Replacement (Cadillac Export)
Fig 1: Tail Lamp Assembly
GM1669953Courtesy of GENERAL MOTORS CORP.
Rear Fog Lamp Replacement (Cadillac Export)

Callout Component Name
Preliminary Procedure 
Open the liftgate in order to access the left tail lamp assembly screws.
1 Tail Lamp Assembly Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Tail Lamp Assembly Locator Pin (Qty: 2)
TIP:  Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts.
3 Tail Lamp Retainer Nut (Qty: 2)
4 Tail Lamp Wiring Harness Assembly Connector
5 Tail Lamp Assembly
  1. The bottom bulb in the left tail lamp is the rear fog lamp bulb and will have a red lens. This is an export only item.
  2. Upon installation, push inward on the tail lamp in order to seat the 2 locating pins.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.