High Mount Stop Lamp Replacement (Yukon Two-mode Hybrid)

2011 Cadillac Escalade Base, AWDSECTION High Mount Stop Lamp Replacement (Yukon Two-mode Hybrid)
Fig 1: High Mount Stop Lamp Assemblies And Nuts
GM1964995Courtesy of GENERAL MOTORS CORP.
High Mount Stop Lamp Replacement (Yukon Two-mode Hybrid)

Callout Component Name
Preliminary Procedure 
Remove the liftgate upper applique. Refer to Liftgate Upper Applique Replacement (GMC Yukon Two-mode Hybrid) .
1 High Mount Stop Lamp Assembly Nut (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 High Mount Stop Lamp Assembly
TIP:  Ensure the high mount stop lamp electrical harness is routed and secured to the back body opening upper applique tabs as removed.
3 High Mounted Stop Lamp Assembly
TIP:  There are no serviceable bulbs in the lamp which uses the (LED) light emitting diode for illumination.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.