SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETUNE-UPENGINE CONTROLS AND FUEL - 6.2L - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL PUMP FLOW CONTROL MODULE REPLACEMENT (COUPE)
2011 Cadillac CTS V, 2D Coupe, Standard

Fuel Pump Flow Control Module Replacement (Coupe)

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Fuel Pump Flow Control Module Replacement (Coupe)
Fig 1: Identifying Fuel Pump Flow Control Module
GM2187219Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Partially remove the right side rear compartment trim panel. Refer to Rear Compartment Side Trim Panel Replacement (Sedan) or Rear Compartment Side Trim Panel Replacement (Coupe) .
1 Fuel Pump Flow Control Module

Procedure

  1. Disconnect the electrical connector.
  2. Release the two integral retainer tabs and remove the module.
  3. If replacing the fuel pump flow control module, program the control module. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.