SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - TAIL LAMP THROUGH YAW SENSORCOMPONENT CONNECTOR END VIEWSVEHICLE COMMUNICATION INTERFACE MODULE (VCIM) X1 (UE1) CONNECTOR END VIEW
2011 Cadillac CTS V, 2D Coupe, Standard

Vehicle Communication Interface Module (VCIM) X1 (UE1) Connector End View

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Vehicle Communication Interface Module (VCIM) X1 (UE1) Connector End View
Fig 1: Vehicle Communication Interface Module (VCIM) X1 (UE1) Connector End View
GM814530Courtesy of GENERAL MOTORS CORP.
Vehicle Communication Interface Module (VCIM) X1 (UE1)

Pin Wire Circuit Function
1 0.35 D-GN 5060 Low Speed GMLAN Serial Data
2 0.35 BN/WH 2517 Keypad Red LED Signal
3 0.35 YE/BK 2516 Keypad Green LED Signal
4-5 - - Not Used
6 0.35 L-GN/BK 2515 Keypad Supply Voltage
7 0.8 BK/WH 851 Ground
8-9 - - Not Used
10 0.35 TN/BK 2500 High Speed GMLAN Serial Data Bus+
11 0.35 D-GN/WH 2514 Keypad Signal
12 0.35 TN 2501 High Speed GMLAN Serial Data Bus-
13-14 - - Not Used
15 0.8 RD/WH 3340 Battery Positive Voltage
16 - - Not Used
Connector Part Information 
  • Harness Type: Instrument Panel
  • OEM Connector: 917981-1
  • Service Connector: 15306351
  • Description: 16-Way F 040/070 Hybrid Series (WH)
Terminal Part Information 
  • Pins: 1-3, 6, 10-12
  • Terminated Lead: 13575804
  • Release Tool: J-38125-559
  • Diagnostic Test Probe: J-35616-16 (L-GN)
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: J/J
  • Pins: 7, 15
  • Terminated Lead: 13575804
  • Release Tool: J-38125-559
  • Diagnostic Test Probe: J-35616-16 (L-GN)
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: K/K
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.