SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - TAIL LAMP THROUGH YAW SENSORCOMPONENT CONNECTOR END VIEWSTURN SIGNAL/MULTIFUNCTION SWITCH X2 CONNECTOR END VIEW
2011 Cadillac CTS V, 2D Coupe, Standard

Turn Signal/Multifunction Switch X2 Connector End View

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Turn Signal/Multifunction Switch X2 Connector End View
Fig 1: Turn Signal/Multifunction Switch X2 Connector End View
GM1862242Courtesy of GENERAL MOTORS CORP.
Turn Signal/Multifunction Switch X2

Pin Wire Circuit Function
1-6 - - Not Used
7 0.35 PU 524 Headlamp Dimmer Switch High Beam Signal
8 0.35 BK/WH 651 Ground
9 - - Not Used
10 0.35 BN 1356 Flash To Pass Switch Signal
Connector Part Information 
  • Harness Type: Steering Column
  • OEM Connector: AIT2PB-10-1BH
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 10-Way F AIT II Series (GY)
Terminal Part Information 
  • Terminated Lead: 13575845
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.