SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - INFLATABLE RESTRAINT ROOF RAIL THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSLIFTGATE MODULE (LGM) X1 CONNECTOR END VIEW
2011 Cadillac CTS V, 2D Coupe, Standard

Liftgate Module (LGM) X1 Connector End View

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Liftgate Module (LGM) X1 Connector End View
Fig 1: Liftgate Module (LGM) X1 Connector End View
GM1566784Courtesy of GENERAL MOTORS CORP.
Liftgate Module (LGM) X1

Pin Wire Circuit Function
1 0.35 L-GN 6112 Power Liftgate On/Off Switch Signal
2 - - Not Used
3 0.35 D-GN 3033 Liftgate Close Signal
4 0.35 D-GN 5512 Liftgate Ajar Switch Signal
5 0.35 PK/BK 6000 Liftgate Ajar Switch Signal
6 0.35 GY 7000 Liftgate Ajar Switch Signal
7 0.35 L-GN 5060 Low Speed GM LAN Serial Data
8 0.5 WH/BK 6126 Liftgate Object Sensor Signal
9-13 - - Not Used
14 0.35 GY 5797 Rear Closure Handle Switch Open Signal
15 - - Not Used
16 0.35 PU/WH 5801 Low Reference
Connector Part Information 
  • Harness Type: Liftgate
  • OEM Connector: 15136073
  • Service Connector: 15136073
  • Description: 16-Way F Kaizen 64 Series (BK)
Terminal Part Information 
  • Terminated Lead: 13575845
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.