SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - INFLATABLE RESTRAINT ROOF RAIL THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSINFLATABLE RESTRAINT STEERING WHEEL MODULE COIL X1 CONNECTOR END VIEW
2011 Cadillac CTS V, 2D Coupe, Standard

Inflatable Restraint Steering Wheel Module Coil X1 Connector End View

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Inflatable Restraint Steering Wheel Module Coil X1 Connector End View
Fig 1: Inflatable Restraint Steering Wheel Module Coil X1 Connector End View
GM1862241Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Steering Wheel Module Coil X1

Pin Wire Circuit Function
1 0.35 TN 28 Horn Relay Control
2 0.35 PU 1375 Remote Radio Control Supply Voltage
3 0.35 PU/WH 7005 LED Dimming Signal
4 0.5 BK 650 Ground
5 0.35 GY 1884 Cruise Control Switch Signal
6 0.35 D-GN/WH 7158 Cruise Control Indicator Dimming Signal
7 0.35 D-BU 1796 Steering Wheel Controls Signal
8 0.35 YE 1996 Remote Shift Selector Signal
9-10 - - Not Used
Connector Part Information 
  • Harness Type: Steering Wheel
  • OEM Connector: 15269795
  • Service Connector: 13576634
  • Description: 10-Way F AIT II Series (BK)
Terminal Part Information 
  • Terminated Lead: Pending
  • Release Tool: J-38125-215A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: Service by Harness - See Part Catalog
  • Core/Insulation Crimp: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.