SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR CLUTCH THROUGH BODY CONTROL MODULECOMPONENT CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) X6 CONNECTOR END VIEW
2011 Cadillac CTS V, 2D Coupe, Standard

Body Control Module (BCM) X6 Connector End View

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Body Control Module (BCM) X6 Connector End View
Fig 1: Body Control Module (BCM) X6 Connector End View
GM1664502Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) X6

Pin Wire Circuit Function
1 0.8 GY/BK 690 Courtesy Lamp Relay Control
2 0.8 L-GN 24 Backup Lamp Supply Voltage
3-11 - - Not Used
12 0.35 PK/BK 1303 Trunk Ajar Switch Signal (without Wagon)
13 - - Not Used
14 0.35 L-GN/BK 748 Right Rear Door Ajar Switch Signal
15 0.35 L-BU/BK 747 Left Rear Door Ajar Switch Signal
16 0.35 D-BU/WH 1179 Left Rear Door Open Switch Signal
17-25 - - Not Used
Connector Part Information 
  • Harness Type: Instrument Panel
  • OEM Connector: 15482793
  • Service Connector: 88988842
  • Description: 25-Way F HIT Series (PK)
Terminal Part Information 
  • Pins: 1-3
  • Terminated Lead: 13327199
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-35 (VT)
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: C/A
  • Pins: 12, 14-16
  • Terminated Lead: SEALED: 13576402 UNSEALED: 13575870
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.