SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEMSREPAIR INSTRUCTIONSACCESSORY AND LIFTGATE CONTROL MODULE REPLACEMENT (WAGON)
2011 Cadillac CTS V, 2D Coupe, Standard

Accessory and Liftgate Control Module Replacement (Wagon)

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Accessory and Liftgate Control Module Replacement (Wagon)
Fig 1: Accessory And Liftgate Control Module (Wagon)
GM2280366Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the liftgate lower trim finish panel. Refer to Liftgate Lower Trim Finish Panel Replacement (Wagon) .
1 Accessory and Liftgate Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Push in tabs to release module.
  3. Reprogram the control module if replaced. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.