Rearview Camera Image Display Module Replacement (Coupe)

2011 Cadillac CTS V, 2D Coupe, StandardSECTION Rearview Camera Image Display Module Replacement (Coupe)
Fig 1: Rearview Camera Image Display Module
GM2363088Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure:Β 
Remove the rear compartment lid lower molding. Refer to Rear Compartment Lid Lower Molding Replacement (Sedan) or Rear Compartment Lid Lower Molding Replacement (Coupe) .
1 Rear Compartment Lid Applique Bracket Bolts (Qty: 2)
CAUTION: Refer to FASTENER CAUTION .

Tighten:Β  7 N.m (62 lb in)

2 Rear Compartment Lid Applique Bracket
Procedure:Β 
Remove the bracket to gain access to the camera.
3 Rearview Camera

Procedure

  1. Disconnect the electrical connector.
  2. Depress the clip fingers and push outward to remove the rearview camera from the applique.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.