Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011CTS V, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSIMMOBILIZER SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B302A (WITH ATH)CIRCUIT/SYSTEM VERIFICATION
2011 Cadillac CTS V, 2D Coupe, Standard
Circuit/System Verification
2011 Cadillac CTS V, 2D Coupe, StandardSECTION Circuit/System Verification
- Turn the ignition ON.
- Observe the security indicator. After approximately 10 minutes, the indicator will turn off.
- Turn the ignition OFF and wait 5 seconds.
- Repeat steps 2-4 two more times for a total of 3 cycles or 30 minutes.
- Turn the ignition ON. The start disable will now be cleared.
- Using the Red Emergency Button, notify the OnStar advisor that the Ignition Block on the vehicle has been cleared and to update the account status.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.