Windshield Wiper System Module Replacement

2009 Cadillac Escalade ESV AWDSECTION Windshield Wiper System Module Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper System Module
GM1669964Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement (Flat Blade )  or Windshield Wiper Arm Replacement (Conventional)  or Windshield Wiper Arm Replacement (Chevrolet Tahoe Two-mode Hybrid) .
  2. Remove the air inlet grille panels. Refer to Air Inlet Grille Panel Replacement .
1 Windshield Wiper System Module Assembly Bolt (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)

2 Windshield Wiper System Module Assembly
Tip:  Raise the module and disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.