SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2009ESCALADE ESV AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 562 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT (AVALANCHE/ESCALADE EXT)
2009 Cadillac Escalade ESV AWD

Remote Control Door Lock Receiver Replacement (Avalanche/Escalade EXT)

2009 Cadillac Escalade ESV AWDSECTION Remote Control Door Lock Receiver Replacement (Avalanche/Escalade EXT)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remote Control Door Lock Receiver
GM2164135Courtesy of GENERAL MOTORS COMPANY
Remote Control Door Lock Receiver Replacement (Avalanche/Escalade EXT)

Callout Component Name

Preliminary Procedures

  1. Disable roof rail SIR system. Refer to SIR Disabling and Enabling .
  2. Remove body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase) , Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT) , Body Lock Pillar Garnish Molding Replacement (Extended Wheelbase) .
  3. Remove rear upper garnish molding. Refer to Rear Upper Garnish Molding Replacement (Avalanche/Escalade EXT) .
1 Remote Control Door Lock Receiver

Procedure

  1. The module slides and snaps into the body structure.
  2. Disconnect the antenna and electrical connection.
  3. If a replacement module is installed, program the module. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.