SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2009ESCALADE ESV AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 235 (BOLTED EXTERIOR BODY PANELS AND CLOSURES)REPAIR INSTRUCTIONSCARGO BOX STOWAGE BOX LID REPLACEMENTINSTALLATION PROCEDURE
2009 Cadillac Escalade ESV AWD

Installation Procedure

2009 Cadillac Escalade ESV AWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 GMC Yukon XL, 2010 GMC Yukon, 2010 Chevrolet Tahoe, 2010 Chevrolet Suburban, and 2010 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cargo Stowage Box & Bolts
    GM1708946Courtesy of GENERAL MOTORS CORP.
  1. Position the cargo box stowage lid (3) to the vehicle.
    2. NOTE: Ensure that the feather edge is properly sealed to the glass and side panels.
  2. Install the cargo box water run channel.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the bolts to the cargo box stowage lid (1) and tighten to 9 N.m (80 lb in).
  4. Install the bolt inside the cargo box stowage lid assembly (2) and tighten to 9 N.m (80 lb in).
  5. Install the cargo box bridge side inner panel. Refer to Cargo Box Bridge Side Inner Panel Replacement (Avalanche)  or Cargo Box Bridge Side Inner Panel Replacement (Escalade EXT) .
  6. Install the assist handle. Refer to Endgate Assist Handle Replacement (Avalanche) .
  7. Install the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  8. Close the endgate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.