SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2009ESCALADE ESV AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 133 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENT
2009 Cadillac Escalade ESV AWD

Memory Seat Control Module Replacement

2009 Cadillac Escalade ESV AWDSECTION Memory Seat Control Module Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Memory Seat Control Module & Components
GM1678396Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the front driver seat. Refer to Front Seat Replacement - Bucket (without HP2) or Front Seat Replacement - Bucket (with HP2) .
1 Driver Seat Adjuster Outer Finish Cover
Refer to Front Seat Cushion Outer Trim Panel Replacement (with HP2) or Front Seat Cushion Outer Trim Panel Replacement (Manual Seat without HP2) or Front Seat Cushion Outer Trim Panel Replacement (Power Seat without HP2) .
2 Driver Seat Adjuster Inner Finish Cover
Refer to Front Seat Cushion Inner Trim Panel Replacement (with HP2) or Front Seat Cushion Inner Trim Panel Replacement (without HP2) .
3 Driver Seat Riser Finish Cover
Procedure: 
Pull rearward to disengage the cover from the seat riser.
4 Driver Seat Cushion Cover and Pad
Refer to Seat Cushion Trim Cover and Pad Replacement (with HP2) or Seat Cushion Trim Cover and Pad Replacement (without HP2) .
5 Memory Seat Module Nut (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
6 Memory Seat Module

Procedure

  1. Disconnect the electrical connector.
  2. Refer to Control Module References for programming and set-up information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.