SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2007XLR VREPAIR AND DIAGNOSISBODY & FRAMEMIRRORSMIRROR SYSTEMREPAIR INSTRUCTIONSPOWER MIRROR SWITCH REPLACEMENTREMOVAL PROCEDURE
2007 Cadillac XLR V

Removal Procedure

2007 Cadillac XLR VSECTION Removal Procedure
    IMPORTANT: When removing the power mirror switch, place the ignition switch in the OFF position.
  1. Remove the door trim panel. Refer to Door Trim Panel Replacement .
  2. Remove the retainer screws from the back of the upper trim panel.
  3. Remove the upper trim from the door.
    4. Fig 1: View Of Door Panel Inner Energy Absorber
    GM1272532Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner energy absorber from the door panel.
  5. Remove 4 retaining screws from the rear of the armrest.
  6. Remove 1 retaining screw from the forward end of the armrest assembly.
    7. Fig 2: View Of Armrest Assembly & Screws
    GM1271088Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the armrest wire harness and remove the armrest assembly.
    8. Fig 3: View Of Front Door Switch Assembly
    GM1270905Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.