Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCADILLAC2007XLR VREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL VEHICLE DISTANCE MODULE SENSOR REPLACEMENTREMOVAL PROCEDURE

2007 Cadillac XLR V

Removal Procedure

2007 Cadillac XLR VSECTION Removal Procedure

Open the hood.

Fig 1: View Of Left Front Section

GM1239225

Courtesy of GENERAL MOTORS CORP.

Remove the left front section (1) of the air cleaner assembly.

Fig 2: View Of Vehicle Distance Module Sensor Assembly

GM1757535

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector from the forward looking sensor (FLS) (2).

Fig 3: View Of Fascia

GM1239220

Courtesy of GENERAL MOTORS CORP.

Remove the FLS from the fascia (1).

Fig 4: View DSCC Module Bolts

GM1239661

Courtesy of GENERAL MOTORS CORP.

Remove the three bolts (1) attaching the FLS to the bracket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.