Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCADILLAC2007XLR BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIM AND PANELINGREPAIR INSTRUCTIONSREAR WINDOW GARNISH MOLDING REPLACEMENTREMOVAL PROCEDURE

2007 Cadillac XLR Base

Removal Procedure

2007 Cadillac XLR BaseSECTION Removal Procedure

Fig 1: Identifying Distance Between Windshield Header To Leading Edge Of Folding Top Panel

Courtesy of GENERAL MOTORS CORP.

Manually open the folding top as shown in the illustration. Refer to Folding Top Manual Operation .

Fig 2: View Of Bow Trim Panel

Courtesy of GENERAL MOTORS CORP.

Grasp the rear garnish molding and pull to disengage the molding from the retaining clips.
Remove the rear garnish molding

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.