Cruise Control Component Views

2007 Cadillac XLR BaseSECTION Cruise Control Component Views
Fig 1: Identifying Instrument Panel And Passenger Compartment Components
GM1252421Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Dimmer/Head Up Display (HUD) Switch
2 Turn Signal/Multifunction Switch
3 Inflatable Restraint Steering Wheel Module
4 Instrument Panel Cluster (IPC)
5 Air Temperature Sensor - Inside
6 Windshield Wiper/Washer Switch
7 Driver Information Center (DIC) Switch
8 Hazard Switch
9 CD Changer
10 Valet Switch
11 Inflatable Restraint I/P Module
12 Inflatable Restraint I/P Module Disable Switch
13 I/P Compartment Lamp
14 Radio
15 HVAC Control Module
16 Cigar Lighter
17 Courtesy Lamp Switch - Console
18 Folding Top Switch
19 Inflatable Restraint I/P Module Disable Switch LED
20 Traction Control Switch
21 Auxiliary Power Outlet
22 Courtesy Lamp - Console
23 Automatic Transmission Shift Lever
24 Ignition Mode Switch
25 Steering Wheel Controls - Right
26 Horn Switch
27 Data Link Connector (DLC)
28 Steering Wheel Controls - Left
Fig 2: View Of Modules Locations
GM1827080Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Folding Top Module
2 Digital Radio Receiver
2 Adaptive Crusie Control Module
4 Memory Seat Module
5 Driver Door Module (DDM)
6 Radio
7 Instrument Panel Cluster (IPC)
8 Head-Up Display (HUD)
9 Remote Control Door Lock Receiver (RCDLR)
10 EBCM - BPMV
11 Forward Looking Sensor (FLS)
12 Transmission Control Module (TCM)
13 Engine Control Module (ECM)
14 Body Control Module (BCM)
15 Audio Amplifier
16 Steering Column Lock Control Module (Export)
17 Inflatable Restraint Sensing and Diagnostic Module (SDM)
18 Front Passenger Door Module (FPDM)
19 HVAC Control Module
20 Rear Object Sensor Control Module
21 Vehicle Communication Interface Module (VCIM)
22 Antenna Ground Plane
23 Antenna Module - Right
24 Antenna Module - Left
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.