Scan Tool Data List

2007 Cadillac XLR BaseSECTION Scan Tool Data List
Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Driver Door Module (DDM) 
Operating Conditions: Ignition ON, engine OFF
Ext. Driver Door Handle Switch Data Active/Inactive Inactive
Int. Driver Door Handle Switch Data Active/Inactive Inactive
Passenger Door Module (PDM) 
Operating Conditions: Ignition ON, engine OFF
Ext. Psgr. Door Handle Switch Data Active/Inactive Inactive
Int. Psgr. Door Handle Switch Data Active/Inactive Inactive
Remote Control Door Lock Receiver (RCDLR) 
Operating Conditions: Ignition ON, engine OFF
Battery Voltage Signal Data Volts 12.6
Ext. Driver Door Handle Switch Doors & Hatch Active/Inactive Inactive
Ext. Psgr. Door Handle Switch Doors & Hatch Active/Inactive Inactive
Ignition Mode Switch Data Idle/Crank/Accy/Off Off
Int. Driver Door Handle Switch Doors & Hatch Active/Inactive Inactive
Int. Psgr. Door Handle Switch Doors & Hatch Active/Inactive Inactive
Key Fob 1 Battery Signal Key FOB Information Volts/Not Present 2.0
Key Fob 1 Low Voltage Key FOB Information OK/Low OK
Key Fob 2 Battery Signal Key FOB Information Volts/Not Present 2.0
Key Fob 2 Low Voltage Key FOB Information OK/Low OK
Key Fob 3 Battery Signal Key FOB Information Volts/Not Present 2.0
Key Fob 3 Low Voltage Key FOB Information OK/Low OK
Key Fob 4 Battery Signal Key FOB Information Volts/Not Present 2.0
Key Fob 4 Low Voltage Key FOB Information OK/Low OK
Last Key Fob Used Key FOB Information Fob # Fob 1
No. of Fobs Programmed Key FOB Information 0,1,2,3,4 2
Ext. Rear Compartment Lid Release Sw. Doors & Hatch Active/Inactive Inactive
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.