HVAC Control Module Replacement - Auxiliary

2007 Cadillac Escalade AWDSECTION HVAC Control Module Replacement - Auxiliary
Fig 1: View Of Rear Radio Control Assembly & Screws
GM1693793Courtesy of GENERAL MOTORS CORP.
HVAC Control Module Replacement - Auxiliary

Callout Component Name

Preliminary Procedure

  1. Remove the floor console bezel assembly. Refer to Overhead Console Replacement - Rear (w/o DVD) or Overhead Console Replacement - Rear (with DVD) .
  2. Disconnect the electrical connectors from the auxiliary HVAC control module.
1 Screw, Control Assembly - Heater and Air Conditioning (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:Β  1.5 N.m (13 lb in)

2 Control Assembly, Heater and Air Conditioning
Tip:Β  HVAC Control Module must be reprogrammed. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.