SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2007ESCALADE AWDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED & MOVEABLE WINDOW SYSTEMSREPAIR INSTRUCTIONSSEALING STRIP REPLACEMENT - REAR DOOR WINDOW BELT OUTER (ESCALADE)
2007 Cadillac Escalade AWD

Sealing Strip Replacement - Rear Door Window Belt Outer (Escalade)

2007 Cadillac Escalade AWDSECTION Sealing Strip Replacement - Rear Door Window Belt Outer (Escalade)
Fig 1: View Of Rear Side Door Outer Belt Sealing Strip
GM1674929Courtesy of GENERAL MOTORS CORP.
Sealing Strip Replacement - Rear Door Window Belt Outer (Escalade)

Callout Component Name

Preliminary Procedure

  1. Lower the rear side door window to the fully down position.
  2. Tape off the lower window frame to prevent damage to the door.
1 Rear Side Door Fasteners (Qty: 3)
Tip:  Using a suitable tool, work the tool around the upper door frame to assist in loosening the sealing strip from the door flange.
2 Rear Side Door Clips (Qty: 9)
Tip:  Using a suitable tool, work the tool down the front edge of the door frame to loosening the sealing strip from the door flange.
3 Rear Side Door Outer Belt Sealing Strip
Tip: 
  1. Pull upward to release the sealing strip from the door frame.
  2. Install the molding into the window opening by inserting the bottom legs of the molding to the door.
  3. Fully seat the molding to the belt flange between the corner of the door frame.
  4. Fully seat the molding to the upper and lower door frame and insert the fasteners and clips around the flange.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.