Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006STS AWD V8-4.6L VIN AREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRDOOR CONTROL MODULE REPLACEMENT
2006 Cadillac STS AWD V8-4.6L VIN A
Door Control Module Replacement
2006 Cadillac STS AWD V8-4.6L VIN ASECTION Door Control Module Replacement
DOOR CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the door trim panel.
2. Remove the door control module (1) by releasing the retainer tabs (2).
3. Disconnect the electrical connectors (1) from the control module (2).
INSTALLATION PROCEDURE
1. Connect the electrical connectors (1) to the control module (2).
2. Snap the door module (1) onto the mounting studs (2).
3. Install the door trim panel.
4. Refer to Control Module References for programming and setup information. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.