Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX AWD V8-4.6L VIN AREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLETORQUE CONVERTER CLUTCH SOLENOIDSERVICE AND REPAIR
2006 Cadillac SRX AWD V8-4.6L VIN A
Torque Converter Clutch Solenoid: Service and Repair
2006 Cadillac SRX AWD V8-4.6L VIN ASECTION Service and Repair
Torque Converter Clutch (TCC) Solenoid Replacement
Removal Procedure
1. Remove the transmission fluid pan and filter.
2. Disconnect the electrical wiring harness connector (1) from the torque converter clutch (TCC) pulse width modulation (PWM) solenoid valve (2).
3. Using a small screwdriver or pick, remove the TCC PWM solenoid valve retainer from the control valve body.
4. Remove the TCC PWM solenoid valve (1) from the control valve body.
5. Remove the O-ring seals (3-4) from the TCC PWM solenoid valve (1), ONLY if the O-rings are cut or worn.
Installation Procedure
1. Install new O-ring seals (3-4) to the torque converter clutch (TCC) pulse width modulation (PWM) solenoid valve (1), if the O-rings were previously removed.
2. Install the TCC PWM solenoid valve (1) into the control valve body.
3. Install the TCC PWM solenoid valve retainer into the control valve body.
4. Connect the electrical wiring harness connector (1) to the TCC PWM solenoid valve (2).
5. Install the transmission fluid pan and filter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.