Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX AWD V8-4.6L VIN AREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAUL62. WIRING HARNESS INSTALLATION
2006 Cadillac SRX AWD V8-4.6L VIN A
62. Wiring Harness Installation
2006 Cadillac SRX AWD V8-4.6L VIN ASECTION 62. Wiring Harness Installation
Wiring Harness Installation
1. Install the wiring harness connector (55) thru the case (24). Hold the connector and install the wiring harness connector retainer (54).
2. Route the harness to the valve body and connect the following components:
^ Pressure Control Solenoid (357)
^ TCC PWM Solenoid (352)
^ 1-2 Shift Solenoid (368)
^ 2-3 Shift Solenoid (369)
^ 4-5 Shift Solenoid (376)
^ Internal Mode Switch - IMS (602)
^ Input Speed Sensor (44)
^ Output Speed Sensor (42)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.