SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX 4.6 A, AWDREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL AND STEERING COLUMNREPAIR INSTRUCTIONSSTEERING COLUMN WIRE HARNESS ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Cadillac SRX 4.6 A, AWD

Installation Procedure

2006 Cadillac SRX 4.6 A, AWDSECTION Installation Procedure
    Fig 1: View Of Steering Column And Wire Harness Assembly
    GM603937Courtesy of GENERAL MOTORS CORP.
  1. Connect all of the connectors from the new wire harness assembly.
    2. Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
  2. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
  3. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
  4. Install the theft deterrent control module. Refer to Theft Deterrent Control Module Replacement in Theft Deterrent.
    5. CAUTION: Refer to SIR Inflator Module Coil Caution in Cautions and Notices.
  5. Install the wires back into the ignition switch clip located on the side of the ignition switch.
    6. Fig 3: Removing/Installing Plastic Mounted Steering Column Bracket
    GM761444Courtesy of GENERAL MOTORS CORP.
  6. Install the wire harness strap.
  7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.