Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX 4.6 A, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTMEMORY MODULESADJUSTABLE PEDAL SYSTEMREPAIR INSTRUCTIONSACCELERATOR PEDAL ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2006 Cadillac SRX 4.6 A, AWD
Removal Procedure
2006 Cadillac SRX 4.6 A, AWDSECTION Removal Procedure
- Remove the knee bolster bracket. Refer to Knee Bolster Bracket Replacement - Left in Instrument Panel, Gages, and Console.
- Remove the accelerator pedal assembly mounting nuts (4).
- Remove the pedal assembly from the studs.
- Disconnect the electrical connector from the electronic throttle control sensor (3).
- Disconnect the electrical connector from the linear position sensor.
- Carefully lift the retaining tabs on the end of the accelerator pedal cable (1) using 2 thin-bladed tools.
- Disconnect the adjustable accelerator pedal cable (1) from the pedal assembly.
- Remove the accelerator pedal assembly from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.