Window Motor Programming - Express Function

2006 Cadillac SRX 4.6 A, AWDSECTION Window Motor Programming - Express Function

If a door control module has been replaced, the replacement module needs to be reprogrammed. Refer to DCM Programming/RPO ConfigurationΒ  before proceeding to the following procedure.

If the battery on your vehicle has been disconnected, you will need to program each side door window regulator motor in order for the express-UP or express-DOWN feature to operate properly. Keep in mind that if something is obstructing the window from closing or opening and you continue programming, the window will only express-UP or express-DOWN to the spot where the obstruction occurred. You will need to reprogram the side door window regulator motor.

The following steps explain how to program the side door window regulator motors:

  1. Press and hold the power window switch until the window is fully DOWN.
  2. Continue holding the power window switch for approximately 3 seconds.
  3. Press and hold the power window switch until the window is fully UP.
  4. Continue holding the power window switch for approximately 3 seconds.
  5. The power window regulator motor is now programmed for the express function.
  6. Repeat this process for all of the power windows.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.