SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX 4.6 A, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTNAVIGATION SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESDTC B2468TEST DESCRIPTION
2006 Cadillac SRX 4.6 A, AWD

Test Description

2006 Cadillac SRX 4.6 A, AWDSECTION Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 1:  Determines if the malfunction is present.
  2. 2:  Verifies that the DTC sets under normal operating conditions.
DTC B2468

Step Action Yes No
1  Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Turn OFF the ignition.
  2. Disconnect the scan tool.
  3. Open, then close driver door to cancel retained accessory power (RAP).
    IMPORTANT: Do not operate any vehicle system for one minute.
  4. Connect a scan tool.
  5. Turn ON the ignition with engine OFF.
  6. Retrieve DTCs from the navigation radio.
Is DTC B2468 a current DTC?		 Go to Step 3  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
3 Replace the navigation radio. Refer to Control Module References in Computer/Integrating Systems.
Did you complete the replacement?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle according to the Conditions for Running the DTC in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.