SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX 4.6 A, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSELECTRONIC SUSPENSION CONTROL MODULE PROGRAMMING AND SETUPESCM REPLACEMENT
2006 Cadillac SRX 4.6 A, AWD

ESCM Replacement

2006 Cadillac SRX 4.6 A, AWDSECTION ESCM Replacement

If the electronic suspension control module (ESCM) is replaced, the procedures must be perform in the following order:

  1. The ESCM programming, refer to Service Programming System (SPS) .
  2. The bump stop setup procedure. To perform this procedure, lift the vehicle just off the ground to fully extend the suspension. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instructions in ESC Special Functions.
    3. IMPORTANT: The vehicle must be at correct trim height and on a level surface before performing trimset procedure. Refer to Trim Height Inspection Procedure .
  3. The trimset procedure. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instruction in the ESC Special functions.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.