SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2006SRX 4.6 A, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION SYSTEMREPAIR INSTRUCTIONSREAR OBJECT SENSOR REPLACEMENTREMOVAL PROCEDURE
2006 Cadillac SRX 4.6 A, AWD

Removal Procedure

2006 Cadillac SRX 4.6 A, AWDSECTION Removal Procedure
    Fig 1: View Of Rear Object Sensor Electrical Connectors
    GM489061Courtesy of GENERAL MOTORS CORP.
  1. Remove rear bumper fascia. Refer to Fascia Replacement - Rear Bumper in Bumpers.
    2. Fig 2: View Of Rear Object Sensor Assembly
    GM500502Courtesy of GENERAL MOTORS CORP.
  2. Lift the locking tabs on the housing (4) and remove the rear object sensor (1).
    3. Fig 3: View Of Spring & Housing
    GM489063Courtesy of GENERAL MOTORS CORP.
  3. Squeeze the spring (1) and remove it from the housing (2).
    4. Fig 4: View Of Rear Object Sensor Housing
    GM489064Courtesy of GENERAL MOTORS CORP.
  4. Release the tabs on the housing and remove.
    5. Fig 5: Painting Rear Object Sensor Bezel
    GM489066Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear object sensor bezel from the rear fascia.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.