Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2005SRX AWD V8-4.6L VIN AREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAUL39. INPUT SUN GEAR SHAFT ASSEMBLE
2005 Cadillac SRX AWD V8-4.6L VIN A
39. Input Sun Gear Shaft Assemble
2005 Cadillac SRX AWD V8-4.6L VIN ASECTION 39. Input Sun Gear Shaft Assemble
Input Sun Gear Shaft Assemble
1. Inspect the outer race and input shaft for the following:
^ Worn or damaged splines
^ Scoring inside the diameter of the race
^ Wear or cracks
2. Inspect the sprag elements for flat spots.
3. Inspect the cage for distortion or broken ribbon tabs.
4. Inspect the inner bearing for cracks.
5. Install the inner roller bearing (456).
6. Install the new inner race thrust ring (455).
7. Install the outer race washer (458) onto the outer race (459).
8. Install the retaining rings (460) and the forward clutch sprag (461) onto the outer race (459).
9. Install the sprag assembly (460, 461, 459) onto the sun gear shaft (457).
10. Check that the forward clutch sprag rotation freewheels and locks up in the correct direction.
11. Install the input sun gear shaft (8) into the case (24).
1. Inspect the outer race and input shaft for the following:
^ Worn or damaged splines
^ Scoring inside the diameter of the race
^ Wear or cracks
2. Inspect the sprag elements for flat spots.
3. Inspect the cage for distortion or broken ribbon tabs.
4. Inspect the inner bearing for cracks.
5. Install the inner roller bearing (456).
6. Install the new inner race thrust ring (455).
7. Install the outer race washer (458) onto the outer race (459).
8. Install the retaining rings (460) and the forward clutch sprag (461) onto the outer race (459).
9. Install the sprag assembly (460, 461, 459) onto the sun gear shaft (457).
10. Check that the forward clutch sprag rotation freewheels and locks up in the correct direction.
11. Install the input sun gear shaft (8) into the case (24).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.