Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2005SRX AWD V8-4.6L VIN AREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGREAR INTEGRATION MODULE (RIM) - PROGRAMMING/RPO CONFIGURATION
2005 Cadillac SRX AWD V8-4.6L VIN A
Rear Integration Module (RIM) - Programming/RPO Configuration
2005 Cadillac SRX AWD V8-4.6L VIN ASECTION Rear Integration Module (RIM) - Programming/RPO Configuration
BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION (RIM)
GENERAL INFORMATION TO SET UP A REAR INTEGRATION MODULE (RIM)
Before setting up any option ensure the following:
- Ensure the scan tool has been updated with the latest software version.
- Ensure the battery is fully charged.
- Ensure all modules on the serial data line are connected.
SETTING OPTIONS
Select "Set Options" under the DIM special functions menu, and follow the Tech 2 on-screen instructions. The following options need to be set, when the RIM is replaced:
- Intrusion Sensor Part A
- Intrusion Sensor Part B
- Inclination Sensor Part A
- Inclination Sensor Part B
- Alarm Siren Module Part A
- Alarm Siren Module Part B
IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
1. Turn the ignition OFF for 10 seconds.
2. Connect the scan tool to the data link connector.
3. Turn the ignition ON with the engine OFF.
4. Use the scan tool in order to retrieve history DTCs from all modules.
5. Clear all history DTCs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.