Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2005SRX AWD V8-4.6L VIN AREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRREAR INTEGRATION MODULE REPLACEMENT
2005 Cadillac SRX AWD V8-4.6L VIN A
Rear Integration Module Replacement
2005 Cadillac SRX AWD V8-4.6L VIN ASECTION Rear Integration Module Replacement
REAR INTEGRATION MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right rear body side trim.
2. Disconnect the electrical connectors (1) from the rear integration module (RIM).
3. Remove the RIM from the mounting bracket.
INSTALLATION PROCEDURE
1. Install the RIM to the mounting bracket.
2. Connect the electrical connectors (1).
3. Install the right rear body side trim.
4. Reprogram the module. Refer to Control Module References. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.