TV Antenna Amplifier Replacement (Front)

2005 Cadillac SRX AWD V8-4.6L VIN ASECTION TV Antenna Amplifier Replacement (Front)


TV ANTENNA AMPLIFIER REPLACEMENT (FRONT)

REMOVAL PROCEDURE
1. Remove the headliner.




2. Disconnect the electrical connectors (1,2).
3. Remove the bolt (3) securing the antenna amplifier to the vehicle.
4. Slide the antenna amplifier out of the mounting bracket.

INSTALLATION PROCEDURE




1. Slide the antenna amplifier into the mounting bracket.
2. Install the bolt (3) securing the antenna amplifier to the vehicle.

Tighten the bolt to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the electrical connectors (1,2).
4. Install the headliner.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.