2003 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the RIM module (1) to the mounting bracket.
  2. Push the RIM (1) into the mounting bracket until an audible click is heard indicating the locking tabs are fully engaged.
  3. Connect the RIM (1) electrical connectors.
    Fig 1: Installing RIM Module To Mounting Bracket
    G02099418Courtesy of GENERAL MOTORS CORP.
  4. Install the mounting bracket (1) to the vehicle body.
    NOTE: Refer to FASTENER NOTICE
  5. Install the mounting bracket fasteners (2).

    Tighten 

    Tighten the fasteners (2) to 9 N.m (80 lb in).

  6. Install the rear compartment trim. Refer to COMPARTMENT FRONT TRIM PANEL REPLACEMENT - REAR
  7. Program the body control module and restore the personalization settings. Refer to BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION (IPM)  or BODY CONTROL MODULE (BCM) PROGRAMMING/RPO CONFIGURATION (DIM)  .
  8. Restore the drivers personalization settings. Refer to DRIVER PERSONALIZATION
    Fig 2: Installing Mounting Bracket Fasteners
    G02099419Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.