Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Cadillac Seville SLSFACTORY OEM SERVICE PROCEDURE
Section 408 (Body Control System)
WARNING: This page is about a different car, the 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Body Control System
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B1000: Internal Fault
- DTC B1004: Running Check Sum
- DTC B1007: EEPROM Error
- DTC B1009: EEPROM Check Sum Error
- DTC B1013: Calibration ROM Checksum Error
- DTC B1014: ROM Checksum Error
- DTC B1390: 10 Consecutive Readings That The Two Battery Positive Voltages Differ
- DTC B1422: Monitored Ignition Switch Circuits Open Or Shorted
- DTC B1556: Vehicle Odometer Mileage Mismatch
- DTC C0550: Internal Write Malfunction
- Symptoms - Body Control System
- Power Mode Mismatch
- Control Module References
- Repair Instructions
- Description and Operation
- Body Control System Description and Operation
- Notes
- Dash Integration Module (DIM)
- Serial Data Power Mode
- 4-Wire Ignition Switch Table
- Fail-safe Operation
- Serial Data Messages
- Discrete Ignition Signals
- Electrical Load Management
- Idle Boost Functions
- Load Shed Function
- DIM Wake-up/Sleep States
- Instrument Panel Integration Module (IPM)
- Rear Integration Module (RIM)
- Body Control System Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
