2001 Cadillac CateraFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedures

  1. Perform powertrain diagnostic system check. See POWERTRAIN DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC SYSTEM. After performing powertrain diagnostic system check, go to next step.
  2. Using scan tool, clear DTCs. Attempt to start engine. If DTC resets, go to next step. If DTC does not reset, go to step  7 .
  3. Reprogram ECM with correct theft deterrent frequency code. See PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS  under PROGRAMMING. Using scan tool, DTCs. Attempt to start engine. If DTC resets, go to next step. If DTC does not reset, go to step  7 .
  4. Verify equipment being used is functioning properly and all cable connections are clean and tight. Attempt to reprogram ECM again with correct theft deterrent frequency code. Using scan tool, clear DTCs. Attempt to start engine. If DTC resets, go to next step. If DTC does not reset, go to step  7 .
  5. Replace ECM. Program replacement ECM using required equipment. See ENGINE CONTROL MODULE  under PROGRAMMING. Ensure ECM is programmed with theft deterrent code currently on vehicle. After repairs, go to next step.
  6. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Start engine and operate vehicle within code enable criteria. Check for DTCs. If this DTC resets, go to step  2 . If this DTC does not reset, go to next step.
  7. Using scan tool, observe stored information. If scan tool displays any DTCs that you have not diagnosed, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If no DTCs are present, system is okay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.