2001 Cadillac CateraFACTORY OEM SERVICE PROCEDURE

Programming Theft Deterrent System Components

NOTE: All Theft Deterrent Module (TDM) and Engine Control Module (ECM) functions must be programmed using GM Tech 2 scan tool.

TDM must be programmed after installation with (in order) security code, engine type, key cylinder number and VIN number. ECM must be programmed to learn new frequency code. To obtain security code and key cylinder number, contact GM dealer.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.