Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac CateraFACTORY OEM SERVICE PROCEDURE
Electronic Brake Traction Control Module (EBTCM): Removal
- EBTCM is mounted in lower left side of engine compartment. Disconnect negative battery cable. Remove relay center cover. Remove Engine Control Module (ECM) from relay center and move ECM wiring harness to one side. Remove lower radiator hose from engine only and move hose to one side.
- Pull out lock tab from EBTCM harness connector and disconnect connector. Disconnect pump motor connector at bottom of EBTCM. Remove and discard 6 EBTCM-to-Brake Pressure Modulator Valve (BPMV) screws. Using care so as not to damage seal and solenoid valves, pull EBTCM and separate from BPMV. Note location and position of 2 wave springs between EBTCM and BPMV. Remove and discard wave springs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
