Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac CateraFACTORY OEM SERVICE PROCEDURE
Electronic Brake Traction Control Module (EBTCM): Installation
- To install, clean BPMV gasket surface with alcohol. Install 2 NEW wave springs in original location and position between EBTCM and BPMV. Install EBTCM to BPMV. Install 4 NEW top mounting screws and tighten in an "X" pattern to 26 INCH lbs. (2.9 N.m). Install 2 NEW bottom screws and tighten to 26 INCH lbs. (2.9 N.m).
- Connect pump motor connector at bottom of EBTCM. Connect EBTCM harness connector and push in lock tab. Install lower radiator hose to engine. Install ECM into relay center and install relay center cover. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.