2000 Cadillac CateraFACTORY OEM SERVICE PROCEDURE

Remote Keyless Entry Diagnostic System Check

  1. Ensure battery condition, cold cranking amperage and reserve capacity meet specifications. Replace as necessary. Install scan tool to Data Link Connector (DLC). If scan tool powers up, go to next step. If scan tool does not power up, go to SCAN TOOL DOES NOT POWER UPΒ  .
  2. Turn ignition on, engine off. Try to establish scan tool communication with BCM. If communication with BCM is established, go to next step. If communication with BCM is not established, go to SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 SERIAL DATA LINKΒ  .
  3. Select display DTC function for BCM. Record all displayed DTCs and status of displayed DTCs. If DTCs B2556 or B2560 are displayed, go to BODY CONTROL MODULE (BCM) DTC DEFINITIONSΒ  table and perform appropriate test. If DTCs B2556 and B2560 are not displayed, attempt to diagnose system by symptom. See appropriate REMOTE KEYLESS ENTRY SYSTEMS article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.