Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Cadillac CateraFACTORY OEM SERVICE PROCEDURE
Scan Tool Does Not Power Up
- Test battery feed circuit at Data Link Connector (DLC) terminal No. 16 (Red wire) for an open or short to ground. See Figure . If fault is located and repaired, perform diagnostic system check for system affected. If fault is not located and repaired, go to next step.
- Test ground circuit (Black wire) at DLC terminal No. 4 for an open. If fault was located and repaired, perform diagnostic system check for system affected. If fault was not located and repaired, go to next step.
- Inspect for poor connections at terminals No. 4 (Black wire) and No. 16 (Red wire) of DLC. If fault was located and repaired, perform diagnostic system check for system affected. If fault was not located and repaired, go to next step.
- Scan tool may be defective. See scan tool operator's manual. Replace scan tool and perform diagnostic system check for system affected.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
