2000 Cadillac CateraFACTORY OEM SERVICE PROCEDURE

Automatic Level Control (ALC) Diagnostic System Check

  1. Ensure battery condition, cold cranking amperage and reserve capacity meet specifications. Replace as necessary. Install scan tool to Data Link Connector (DLC). If scan tool powers up, go to next step. If scan tool does not power up, go to SCAN TOOL DOES NOT POWER UPΒ  .
  2. Turn ignition on, engine off. Try to establish scan tool communication with ALC sensor. If communication with ALC sensor is established, go to next step. If communication with ALC sensor is not established, go to SCAN TOOL DOES NOT COMMUNICATE WITH CLASS 2 SERIAL DATA LINKΒ  .
  3. Select display DTC function for ALC sensor. Record all displayed DTCs and status of displayed DTCs. If DTCs are displayed, go to BODY CONTROL MODULE (BCM) DTC DEFINITIONSΒ  table and perform correct repair procedure. If no DTCs are displayed, attempt to diagnose system by symptom. See appropriate AUTOMATIC LEVEL CONTROL article in SUSPENSION.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.