Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1998SEVILLE SLS V8-4.6L VIN YREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULSUBASSEMBLY SERVICEOUTPUT SHAFT REMOVAL
1998 Cadillac Seville SLS V8-4.6L VIN Y
Output Shaft Removal
1998 Cadillac Seville SLS V8-4.6L VIN YSECTION Output Shaft Removal
1. Push on the output shaft in order to expose the snap ring. Remove the output shaft snap ring (56).
2. Remove the left side differential gear (118). Remove the thrust washer (117).
3. Remove the output shaft (57) through the opposite end of the case.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.