Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1998SEVILLE SLS V8-4.6L VIN YREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL DATA VALUES
1998 Cadillac Seville SLS V8-4.6L VIN Y
Scan Tool Data Values
1998 Cadillac Seville SLS V8-4.6L VIN YSECTION Scan Tool Data Values
If you have completed the On-Board Diagnostic (OBD) system check, if the diagnostics are functioning properly and if no Diagnostic Trouble Codes (DTCs) display, you may use the Typical Scan Values in the table shown for comparison within the appropriate transmission. These typical values are an average of display values recorded from normally operating vehicles. They represent the display from a normally functioning system.
You should never use a scan tool that displays faulty data. The condition should be reported to the manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.
Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.
Scan tests are performed under the following conditions:
^ Idle
^ Upper radiator hose is hot
^ Closed throttle
^ Park or Neutral
^ Closed Loop
^ Accessories OFF
^ Brake not applied
SCAN TOOL TRANSMISSION DATA 1 VALUE EXAMPLES
SCAN TOOL TRANSMISSION DATA 2 VALUE EXAMPLES
SCAN TOOL TRANSMISSION DATA 3 VALUE EXAMPLES
You should never use a scan tool that displays faulty data. The condition should be reported to the manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.
Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.
Scan tests are performed under the following conditions:
^ Idle
^ Upper radiator hose is hot
^ Closed throttle
^ Park or Neutral
^ Closed Loop
^ Accessories OFF
^ Brake not applied
SCAN TOOL TRANSMISSION DATA 1 VALUE EXAMPLES
SCAN TOOL TRANSMISSION DATA 2 VALUE EXAMPLES
SCAN TOOL TRANSMISSION DATA 3 VALUE EXAMPLES
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.