Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1997SEVILLE SLS V8-4.6L VIN YREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
1997 Cadillac Seville SLS V8-4.6L VIN Y
Oil Pressure Sensor: Service and Repair
1997 Cadillac Seville SLS V8-4.6L VIN YSECTION Service and Repair
Removal Procedure
Notice: Numbers in text correspond to numbered components in image.
1. Raise the vehicle and support.
2. Remove the front splash shield.
3. Remove the electrical connector (2).
4. Remove the sensor (2) from the oil filter adapter (3).
Installation Procedure
1. Install the sensor (2) to the oil filter adapter (3). Tighten the sensor to 12 Nm (106 lb in).
2. Replace the electrical connector (2).
3. Replace the front splash shield.
4. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.