Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1996ELDORADO V8-4.6L VIN 9REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULSUBASSEMBLY SERVICEMANUAL SHAFT ASSEMBLY REMOVAL
1996 Cadillac Eldorado V8-4.6L VIN 9
Manual Shaft Assembly Removal
1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Manual Shaft Assembly Removal
MANUAL SHAFT ASSEMBLY REMOVAL 4T80-E TRANSAXLE
1. Using a pair of pliers, grasp the detent roller end of the detent spring. Remove the detent spring (27).
2. Remove the 13-mm detent roller bolt pivot arm, the sleeve, and the washer (26).
3. Remove the 15-mm manual shaft nut (18). You must hold the detent lever in place when removing the nut in order to prevent damage to the actuator rod.
4. Remove the detent lever (17) and the actuator rod (21)
5. Remove the following parts:
- The manual shaft (16) out through the top of the bell housing
- The manual shaft seal (20)
- The washer (19)
1. Using a pair of pliers, grasp the detent roller end of the detent spring. Remove the detent spring (27).
2. Remove the 13-mm detent roller bolt pivot arm, the sleeve, and the washer (26).
3. Remove the 15-mm manual shaft nut (18). You must hold the detent lever in place when removing the nut in order to prevent damage to the actuator rod.
4. Remove the detent lever (17) and the actuator rod (21)
5. Remove the following parts:
- The manual shaft (16) out through the top of the bell housing
- The manual shaft seal (20)
- The washer (19)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.