Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC1996ELDORADO V8-4.6L VIN 9REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULSUBASSEMBLY SERVICEHOLDING FIXTURE INSTALL
1996 Cadillac Eldorado V8-4.6L VIN 9
Holding Fixture Install
1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Holding Fixture Install
HOLDING FIXTURE INSTALL 4T80-E TRANSAXLE
^ Tools Required
- J 39050 4T80-E Holding Fixture
- J 3289-20 Transmission Support Fixture Base
Caution: To reduce the possibility of personal Injury or transmission damage, make sure, when doing the next step, that all of the bolts for the support fixture are Installed as shown, and that the bolts are tightened to 11 N.m (98 lb. In.).
1. Install the J 39050 4T80-E holding fixture on the transmission.
2. Install the holding fixture and the transmission into the J 3289-20 transmission support fixture base.
3. Position the transmission with the case extension pointing downward in order to allow the fluid to drain.
4. Insert the pin into the base.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.