Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Sensing Position Sensor
1996 Cadillac Eldorado V8-4.6L VIN 9SECTION Rear Sensing Position Sensor
Fig. 124 Rear Sensing Position Sensor Replacement.:
REPLACE
1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Disconnect sensor electrical connector, Fig. 124.
4. Disconnect wires from suspension support.
5. Unlatch sensor locking tabs and remove position sensor from upper and lower ball studs.
6. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.